Beamz Pro BAC552Z Mode D'emploi page 28

A001-A512 Press Up or Down to modify address codes (A001~A512), press ENTER to Save
CH10-CH18 Press Up or Down to modify Channels CH10,CH18, press ENTER to Save
N000-N084 Press Up or Down to choose built-in effects (N000~ N084), default N007, press ENTER to Save
S000-S255 Press Up or Down to modify speed (S000~ S255), default S024, press ENTER to save
Soud Sound-activated
R000-R255 Press Up or Down to adjust red brightness (R000~ R255), press ENTER to save
G000-G255 Press Up or Down to adjust green brightness (G000~ G255), press ENTER to save
B000-B255 Press Up or Down to adjust blue brightness (B000~ B255), press ENTER to save
W000-W255
Press Up or Down to adjust white brightness (W000~ W255), press ENTER to save
M000-M2555 Zoom motor
T000-T100 Display temperature
R032-R255
Press Up or Down to adjust Red LED current (R032-R255), press ENTER to save
G032-G255 Press Up or Down to adjust Green LED current (G032-G255), press ENTER to save
B032-B255 Press Up or Down to adjust Blue LED current (B032-B255), press ENTER to save
W032-W255
Press Up or Down to adjust White LED current (W032-W255), press ENTER to save
M000-M255 Zoom motor current
FA-N Fan set: FA-N Light on indicates the fan is on, FA-Y Starts the fan when it reaches the set
temperature protection point, press ENTER to save
T040-T105 Press Up or Down to set temperature protection point (40°C~105°C), press ENTER to save
Send Press Up or Down to send factory settings parameters to all other fixtures connected. Confirm
sending by pressing the menu button for 3 seconds, otherwise press Confirm to deny the sending.