Publicité
Les langues disponibles
Les langues disponibles
PRODUCT INSTALLATION
POWER SUPPLY
Please use the attached power, note that power voltage and frequency are the same as the marked voltage and
frequency of device when connecting power. Every device's power should be connected separately, so that de-
vice can be controlled individually.
DMX CONNECTION
Connection between lights and DMX must use the shied cable of diameter more than 0.5mm. Please use the
attached 3 pin XL plug/socket to connect the DMX output/input interface. The connection between socket and
cable as below (note the plug/socket's 3 pin number and position).
DMX-OUTPUT
XLR mounting-sockets (rear view)
2
When using standard DMX512 control signal, the last device' s output interface must be connected to a DMX plug. This
plug is putting a 120 ohm resistance between "canon" plug' s 2 pin and 3 pin. Showing as below pic. Sticking this plug
into the last device' s signal output interface, it will avoid the interference during the process of signal transmission.
RIGGING
Attention! The installation must be carried out by qualified service personal only. Improper installation can re-
sult in serious injuries and /or damage to property. Overhead rigging required extensive experience! Working
load limits should be respected, Certified installation materials should be used, the installed device should be
inspected regularly for safety.
MENUS NAVIGATION
MENU
ENTER
1 ∙ Shield
2 ∙ Shield (-)
1
3 ∙ Shield (+)
3
FUNCTION
1
2
3
4
DMX-INTPUT
XLR mounting-plugs (rear view)
2
1
3
-
DESCRIPTION
MENU
Enter/view menu functions
View previous menu
View next menu
ENTER
Enter selected function/OK key
P.14
PIN3
PIN2
Publicité
