Philips BT3222 Mode D'emploi page 3

Caution
- Never immerse the charging
stand in water and do not
rinse it under the tap.
- Never immerse the appliance
in water. Do not use the
appliance in the bath or
shower.
- Never use water hotter than
60 °C to rinse the appliance.
- Only use this appliance for its
intended purpose as shown
in the user manual.
- For hygienic reasons, the
appliance should only be
used by one person.
- Do not use the supply unit in
or near wall sockets that
contain an electric air
freshener to prevent
irreparable damage to the
supply unit.
- Never use compressed air,
scouring pads, abrasive
cleaning agents or aggressive
liquids such as petrol or
acetone to clean the
appliance.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
General
- This appliance can be safely cleaned under the
tap.
- The supply unit is suitable for mains voltages
ranging from 100 to 240 volts.
- The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.
Charging
Charge the product fully before you use it for the
first time and after a long period of non-use.
It takes approximately 1 hour to fully charge the
product. When it is fully charged, the appliance has
a cordless operating time of up to 90 minutes.
1 Make sure the product is switched off.
2 Insert the small plug into the product (Fig. 2).
3 Put the adapter in the wall socket.
- The charging light on the supply unit lights up
green to indicate that the product is charging.
Note: The charging light on the supply unit does
not change color and does not go out when the
product is fully charged.
4 After charging, remove the adapter from the
wall socket and pull the small plug out of the
product.
Optimizing the lifetime of the
rechargeable battery
When you have charged the product for the first
time, we advise you to use it until the battery is
completely empty. Continue to use the product
until the motor almost stops running during a
session. Then recharge the battery. Follow this
procedure at least twice a year.
Note: An adapter plug may be necessary for cord
usage in some foreign countries. Use an
attachment plug adapter of the proper
configuration for the power outlet.
Using the product
Note: Switch off and clean the product and
attachments after each use.
- Use this product for its intended household use
as described in this manual.
- For hygienic reasons, the product should only
be used by one person.
Always comb the beard and/or moustache with a
fine comb before you start trimming.
Be careful when you trim for the first time. Do
not move the trimmer too fast. Make smooth
and gentle movements.
Switching the product on and off
- Slide the on/off button up to switch the
product on or off (Fig. 3).
Trimming with guard
Note: When you trim for the first time, start at the
highest length setting to familiarize yourself with
the product.
Use the trimming guard attached to the cutting
element to trim your beard and moustache in your
preferred style. Turn the zoom wheel to choose
from 11 length settings ranging from 0.5mm to
10mm (1/32in. to 13/32in.).
1 Slide the trimming guard straight into the
guiding groove of the product (Fig. 4).
2 Turn the zoom wheel to the desired setting (Fig.
5). The desired hair length setting is shown in
the center of the zoom wheel.