Hoover H9A3TCEX-S Mode D'emploi page 60

2. WATER CONTAINERS
The water removed from the laundry during
the drying cycle is collected in a container.
When the container is full, an indicator light,
or on some models a message on the
display, will advise you that it MUST be
emptied (however, we recommend to empty
it after each drying cycle).
Very little water will collect during the
first few cycles of a new machine as an
internal reservoir is filled first.
To remove the container tank in
door drawer *
1. Gently pull out the water container
holding the handle (A).
When it is full the water container will
weigh about 6 kg.
2. Tilt the water container to empty the
water out through the spout (B).
When empty, replace the water container
back as shown; (C) first insert the base of
the container into position as shown (1)
then gentle push the top into position (2).
3. Press the programme start button to
restart the cycle.
*
Depending on model
ONLY FOR MODELS WITH DRAIN
HOSE KIT
If you have the option of drainage
near to the dryer you can use the
discharge kit to provide a permanent
drainage for the water collected in the
container of the dryer. This means
that you don't have to empty the water
container.
To remove the container bottom
water drawer *
1. Gently pull the top of the kickplate so
that it unclips from the dryer. The bottom
section can then be unhinged allowing
the kickplate to be completely removed (A).
2. Pull firmly on the handgrip and slide the
water container out of the dryer (B).
Support the container with both hands
(C). When full, the water container will
weigh about 4 kg.
3. Open the lid located on the top of the
container and empty the water at the end
of each drying cycle and before starting
the next one (D).
4. Refit the lid and slide the water container
back into position (D). PUSH FIRMLY
INTO PLACE.
5. Refit the kickplate by engaging the
hinges at the top and 'snapping' the lower
clips into place.
*
Depending on model
60