Publicité
Les langues disponibles
Les langues disponibles
- Unscrew the nut (4) clockwise
- Take off the cap (5) and outer ring (6), than remove
the blade (1), taking care not to take off the inner ring
(7) and spacer (8).
When mounting,
- If they were taken off during disassembly, refit the
spacer (8) and the inner ring (7), making sure that the
inner ring's (7) grooves match perfectly with the angle
transmission.
- Refit the blade (1) and the outer ring (6), with the pro-
truding edge toward the blade.
- Refit the cap (5) and the nut (4), fully tightening it in an
anticlockwise direction.
- Remove the wrench (2) to restore blade rotation.
• Cutting line head
NOTE: The cutting line head has a left-hand thread
and so must be unscrewed in a clockwise direction and
screwed up anticlockwise.
- Insert the wrench supplied (2) into the specific hole in
the angle transmission (3) and rotate the cutting line
head (1) by hand until the wrench enters the inner
hole, blocking rotation.
- Remove the cutting line head (1) unscrewing it in a
clockwise direction.
When mounting:
- If they were taken off during disassembly, refit the
spacer (5), the inner ring-nut (4) and the outer ring
(6),making sure that the inner ring-nut (4) grooves-
match perfectly with the angle transmission.
- Fit the cutting line head (1) screwing it up in an anti-
clockwise direction.
- Remove the wrench (2) to restore shaft rotation.
Preparing to Work
Checking the machine
Before starting work please:
- check that all the screws on themachine and the cut-
ting device are tightly fastened;
- check that the cutting device is undamaged and that
the 3 or 4-point metal blades (if fitted) are properly
sharpened;
- check that the air filter is clean;
- check that the protection devices are well fastened
and working efficiently;
- check the handgrips are well fastened.
Using the Machine
To respect people and the environment:
- Try not to cause any disturbance.
- Scrupulously comply with local regulations and
provisions for the disposal of waste materials
after sawing.
- Scrupulously comply with local regulations and
provisions for the disposal of oils, petrol, dam-
aged parts or any elements which have a strong
impact on the environment.
Adjusting the carry strap
The design and type of carry strap may vary.
• Put on the shoulder strap (1).
GB-31
Publicité
