Eldom bess HTS20 Manuel D'utilisation page 9

GENERAL DESCRIPTION
1. Interchangeable modelling tips
2. Air outlet
3. Attachment release button
4. Main body
5. On/Off switch with power settings
6. Air inlet
7. Hang ring
8. Power cord
INTENDED USE
Hair styler HTS20 is a universal device for hair styling. The hot air enables efficient and easy drying
of hair, while the 4 interchangeable ends allow styling of hair of various lengths.
MODELLING TIPS (1)
The tips (1) make it easier to style hair. Use the tips (1) interchangeably.
a. concentrator for fast drying,
b. flat modelling brush,
c. large oval brush for detangling hair and adding volume.
d. round brush for shaping curls, waves and for smoothing and volumising hair.
OPERATION
•
Before connecting the hair dryer to the power source, make sure that the switch (5)
is set to position "0".
•
Fit one of the tips into the air outlet (2) - fig. I.
•
To remove the tip (1), press the lock button (3), turn the tip slightly to the left and pull upwards
- fig. II.
•
After connecting the appliance to the mains with the parameters as specified
in the manual, start the appliance with the switch (5):
pos. "0" - dryer switched off,
-
pos. "1" - strong blow, "cool air",
-
pos. "2" - low airflow, low temperature for slightly damp, not too thick or short hair,
-
pos. "3" - strong fan, high temperature, fast drying of wet or thick hair.
-
CLEANING AND MAINTANANCE
•
Before cleaning, turn the switch (5) to the "0" position and disconnect from the mains and wait
until it has cooled down completely.
•
Never immerse the hair styler in water.
•
Casing and power cord can be cleaned with soft dry or slightly damp cloth.
•
The air inlet (6) and outlet (2) should be cleaned with soft brush
WARRANTY
•
This appliance is designed for domestic use only.
•
It cannot be used for professional purposes or for other than the intended use.
•
Improper use will nullify the guarantee.
OPERATING INSTRUCTION
4 in 1 HOT AIR BRUSH HTS20
TECHNICAL DETAILS
•
power:
800-1000W
•
mains supply:
220-240V~ 50-60Hz
EN
9