Publicité
Les langues disponibles
Les langues disponibles
Keep the warranty, the receipt and the instruction booklet for any further consultation.
After removing the packaging, make sure that the appliance is intact and in case of visible damage, do not use
it and contact professionally qualified personnel.
Do not leave parts of the packaging within the reach of children to avoid the danger of suffocation.
Before connecting the appliance, make sure that the voltage in the socket corresponds to the details indicated
on the plate.
If the plug and socket are not compatible, have the socket replaced with a suitable type by professionally
qualified personnel.
Do not use adapters or extensions that do not comply with the current safety regulations or that exceed the limits
of the current carrying capacity.
Do not pull on the power cable or the appliance itself to take the plug out of the socket.
The use of any electrical appliance requires the observance of certain fundamental rules, in particular:
- Do not touch the appliance with wet or damp hands.
- Do not leave the appliance exposed to atmospheric agents (rain, sun).
- Do not subject it to impacts.
If there is a fault or abnormal operation of the appliance, immediately
disconnect the plug, do not tamper with it and contact an authorised Service Centre.
If you decide to no longer use this type of appliance, it is advisable to make it inoperative by cutting the power
cable, obviously after disconnecting it from the power socket.
To avoid dangerous overheating, it is advisable to unwind the power cable along its entire length.
For safety reasons, the appliance cannot be disassembled.
Do not use the appliance outdoors.
Do not process hard food such as ice or meat with bones as they could damage the appliance, break the blades
and cause injury.
To keep the blade seal efficient, do not run the appliance empty.
The appliance is equipped with a safety device that stops operation in the event of abnormal overheating.
Should this device intervene, it is necessary to disconnect the appliance from the power supply and let it cool
for at least 15 minutes.
WARNING: Do not use this appliance near bathtubs, showers, sinks or other vessels that contain water.
Use only the accessories supplied with the appliance.
Keep the appliance and its cable away from heat sources.
To blend food in a saucepan, remove the saucepan from the stove and allow the contents to cool below 70°C
before inserting the stem and blending; do not leave the stem in the pan.
To avoid splashes, immerse the blades completely in the food to be blended.
Hard ingredients such as legumes, soybeans etc. they must be soaked in water before processing.
(see the image on page 2)
1 - Speed button I (minimum)
2 – Speed button II (maximum)
3 - Motor body
4 - Stem
5 - Stem blades
Technical data: see the label on the appliance.
Contact with food
Only these parts are intended for contact with food, under the conditions indicated:
Parts intended for contact
with food
Stem (4), stem blades (5)
- These parts can only be used with this appliance. Do not use the parts separately for other applications.
- Before using the appliance for the first time wash the parts intended for contact with food as indicated in the
Maintenance section.
TECHNICAL INFORMATION
USER INSTRUCTIONS
Types of food
All
Maximum temperature
70°C
Maximum time of
contact
5min
7
Publicité
