Settings
By using Dante-compatible audio equipment (sold separately), the
following settings can be modified.
When modifying settings, change the mode to "REMOTE."
Mode
: LOCAL/REMOTE
Gain
: MUTE/+30 dB/+40 dB/+50 dB
Low-cut
: ON/OFF
Ring LED (Red) : ON/OFF
Ring LED (Green): ON/OFF
Settings Memory
The last settings are automatically saved.
There is no need to perform setup again the next time the product
is turned on.
* The mode is set to "LOCAL" each time the product is turned on.
* While in "LOCAL" mode, the setting data cannot be read
externally.
Factory default settings
The factory default settings are as follows:
Mode
: LOCAL
Gain
: +40dB
Low-cut : OFF
How to Install
• Install the product properly according to instructions in this
user manual.
• Before installing on a wall or ceiling, consult with your
Audio-Technica dealer or a professional contractor in order to
avoid electrical shock, malfunction, accident or fire.
• Screws for mounting the product on walls or ceilings are not
included.
Use commercially-available screws that are appropriate for the
materials and thickness of the location where the product is to
be installed.
• When installing on a wall or ceiling, mount the product using a
standard 2-gang electrical box.
* Ensure that the commercially-available 2-gang electrical box conforms to
the mounting-position measurements of the product.
Standard 2-gang electrical box
(sold separately)
Screws (sold
separately)
Fixing screws (included)
1 Turn the cover counter-clockwise and remove it.
2 Use the included fixing screws to fix the product to the
mounting box.
* When mounting on a wall, orient the product so that the
arrow mark is pointing upward.
3 Attach the cover while making sure that the protruding bumps
are in the correct positions.
4 Turn the cover clockwise to secure it tightly.
*Ensure that the cover is secured tightly.
Ring LED (Red) : OFF
Ring LED (Green): OFF
Mounting position
measurements
(Unit: mm)
83
Arrow
• Thoroughly check the quality, strength, thickness, etc. of
the building material in the location where the product will
be mounted. Audio-Technica takes no responsibility for
accidents or damage resulting from the product falling
because it was mounted improperly or in an insufficiently
sturdy location.
• When mounting the product to the mounting box, be sure
to use the included fixing screws.
• Ensure that the screws of the mounting box are securely
tightened. If they loosen, the product may fall and result in
an accident or injury.
• Be sure to connect an Audio-Technica condenser hanging
microphone.
Painting the Cover
• The cover can be painted using commercially-available spray
paint.
Remove the cover when painting it.
• Do not paint the reverse side of the cover.
Doing so will prevent the cover from being properly reattached.
Technical Data
Input jack
:TB3M-type connector
Output jack
:RJ-45
Frequency response
:20 to 20,000 Hz
Low-cut
:80 Hz, 18 dB/oct
Network interface
: 100 Mbit Ethernet, supporting Auto-negotiation
function
Cable requirements
:CAT5e or above (STP cable recommended)
Power supply
:Conforms with PoE IEEE 802.3af
Power consumption
:1.5 W
External measurements :Φ148 x 47 mm
Weight
:Approx. 330 g
Included accessories
:Fixing screw x4
Specifications are subject to change without notice due to improvements.
* All company names and product names mentioned are trademarks or
registered trademarks of their respective companies.
2
Caution
JA
EN
KO
CN
TW