MAGICKWOODS Elements EUROSTONE 49998 Instructions D'installation

PACKAGE CONTENTS
Base (x 1)
MODEL 49998
OVERALL DIMENSIONS (WITH TOP):
24"W x 17"D x 33"H
(12-3/4" cabinet depth without sink)
WARNINGS & CAUTIONS
WARNING:
Two people are required for safe installation. Take extra
precautionary measures to ensure a secure grip on the vanity
base and top when lifting.
CAUTION:
• The bathroom floor and wall must be finished prior to
installation of the vanity and vanity top.
• Do not use water that exceeds temperatures of 140°F/46°C.
• Do not drop any objects onto the vanity top. Vanity tops are
susceptible to breaking when objects fall onto them. Any
cracks found should be reported before installation.
• Do not place any sharp or abrasive objects on the bare
surface of the vanity top.
INSTALLATION
1: Removing old vanity (if applicable): 1) Turn off the water supply and drain out. 2) Disconnect
the supply lines from the faucet. 3) Remove the old vanity top and vanity. If the new vanity is not
installed immediately, temporarily stuff a rag into the drain pipes.
2: Using a level, locate any uneven floor and/or wall areas where your vanity will be installed.
Unevenness can cause your vanity to become misaligned resulting in twisting of the cabinet.
Repair any uneven areas by reducing high spots or shimming low spots.
3: 1) Provide sufficient protection on the floor to protect the vanity from damage. 2) Tilt the vanity
backwards and remove the shipping feet from the bottom of the vanity base using a pair of pliers
(A - not included). Figure 1.
4: 1) Place the vanity in the desired position taking into account the location of your plumbing.
2) Ensure the vanity is level front to back and at both sides.
5: Secure the vanity to the wall by inserting (x 2) #8 x 2" screws (C - not included) through the back
rail of the vanity. Figure 2. It is recommended that the vanity be installed to at least one wall stud.
If you are unable to locate wall studs, it is recommended that you use wall anchors (D - not included) to secure the vanity.
6: Attach the (x 2) knobs by using the (x 2) 1" screws. Figure 3.
Top (x 1)
Knobs (x 2)
1" screws (x 2)
Bumpers (x 4)
Faucet and drain
not included.
EUROSTONE VANITY ENSEMBLE
MODEL 49998 • INSTALLATION INSTRUCTIONS
Questions? Call our customer service department at
1-855-995-5578, 8:30 a.m. - 5 p.m., EST, Monday - Friday
PREPARATION
Tools required for assembly (not included):
• pliers (A)
• tape measure
• electric drill with #2 drill bit (B)
• level
• (x 2) #8 x 2" screws (C)
• (x 2) wall anchors - if the vanity will not be screwed to wall studs (D)
• silicone (E) - optional
Estimated installation time: 2-1/2 hours (including removal of old
vanity if applicable)
CARE & MAINTENANCE
• To maintain the beauty of the furniture finish, avoid placing the
vanity in direct sunlight.
• Avoid exposing the vanity to extreme temperatures by installing
away from heat and air vents.
• Dust frequently with a clean, soft and dry cloth.
• Wipe away any water or liquid spills on the vanity base
immediately with a clean, soft and dry cloth.
• Clean the vanity top only with non-abrasive cleaners or
mild detergents - do not use powder cleansers. For
extremely stubborn stains, use a small amount of acetone
on a cloth and gently rub out the stain.
or email contactus@magickwoods.com.
A Figure 1