• This appliance is not intended for using with an external timer or
a separate system of remote control.
• To unplug, pull from the plug, never from the cable.
• It must not be used outdoors.
• The cleaning and maintenance done by users, can not be done
by children without any supervision, unless they are over 8 years
and they are under supervision.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
INSTRUCTIONS OF USE
• Before using for the first time, clean the grill with a damp cloth. Next, dry carefully and spread a little oil with a
cloth or kitchen roll.
• Before each use pour some oil on the grill.
• Place the appliance on a flat and heat resistance surface.
• The tray (7) must be in place, otherwise, the juices and fat resulting from the cooking will spill onto the surface.
• If you wish you can slope the grill making easier the fat and grease collection. To do that turn the tip-up support
(5) until the end and remaining in that position leave the grill on the surface.
• Insert the connector (1) into the base (4), bearing in mind that the temperature selector (2) is in the top position.
• Turn the temperature selector (2) to the desired position, according to the type of food you are going to prepare
using as a reference the selected temperature of the pilot light position (3). Firstly it is advisable to put the
selector to its highest position, to let the grill reach, as soon as possible, a good temperature. After that you can,
if you consider it convenient, change the selector position.
• Plug into the mains. The pilot light (3) will go on. When the pilot light goes off the grill will have reached the
selected temperature.
• Place the food on the grill (6).
• Always use wooden utensils to move or turn the food over. The use of forks or other metal utensils may scratch
the surface.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning, unplug the appliance from the mains and remove the connector from its base.
• Do not wait for the grill to cool completely. The cleaning of the surface will be easier if it is still warm. It is enough
to use a slightly dampened cloth and if there were some difficult residues they may be cleaned with a cloth
dampened in a little oil.
• It may be cleaned with soap and water, taking care to rinse carefully afterwards.
• Important: If you have immersed it in water or rinsed with abundant water you must dry the base of the
connector (4) and the pins before using it again.
• Do not use abrasive or chemical products, metallic scourers, and such may deteriorate the protection.
• The tray (7) may be cleaned with water and detergent suitable for the dishwasher.
• The connector must always be cleaned with a dry cloth and must never be immersed in water.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
11