Coby Snapp Manuel D'instructions page 8

getting started
Â
Please read and complete the following steps to
begin using your digital video camera.
Install the Battery
1. Remove the battery compartment door by slid-
ing it toward the base of the camera.
2. Load the battery pack into the compartment as
shown in the diagram. The text on the battery
should be visible and the metal contacts should
face left.
3. Replace the battery compartment door and
snap it into place.
Page 8 Page 8
The battery used in this device may present
a fire or chemical hazard if mistreated. Do
not recharge, disassemble, incinerate, or
heat the batteries. Used batteries should be
disposed of safely.
Keep batteries out of the reach of children.
Charging the Battery
1. Turn off the camera.
2. Connect the camera to the USB port of a com-
puter. The LED light will turn on while charging
and will turn off when the battery is fully charged.
Fully charge the battery before using the
camera for the first time.
For instructions on how to connect the cam-
era to a computer, please read the "Trans-
ferring files to a Computer" section of this
manual.
Getting Started Getting Started