curt 55373 Manuel D'installation

55373
LINCOLN LS
INSTALLATION QUESTIONS?
CALL TECHNICAL SUPPORT AT
1-877-287-8634
5/24/2010
1. Open the trunk and remove the floor
coverings and rear scuff panel. On the
drivers and the passenger side's partially
remove the felt trunk liner to expose the
vehicles taillight wiring harness.
2. On the drivers side seperate the vehicles
taillight wiring harness connectors being sure
not to damage the locking tabs. Insert the
T-connecter end with the yellow wire
in-between the separated connectors.
3. Route the T-connecector end with the
green wire out from behind the partially
removed felt trim liner and behind the
removed scuff panel and behind the felt trim
liner on the passenger side. Repeat step 2 on
the passenger side using the green wire.
4. Route the black power wire from the
battery in the trunk to the converter as shown
on the CME-PCL-INS sheet included.
5. Locate a suitable grounding point near the
connector such as an existing screw with nut
in the vehicle's frame or drill a 3/32" hole and
secure white wire using eyelet and screw
provided.
6. Adhere the black converter box to the
frame of the car using the double-sided tape
provided. Secure any loose parts of the
T-connector with the cable ties provided.
7. Route the 4-flat wire to the center of the
vehicle and out the trunk when in use. When
not in use roll up and store in an out of the
way location in the trunk.
WARNING!
Verify miscellaneous items that may be hidden
behind or under any surface before drilling to
avoid damage and/or personal injury.