This symbol means that this unit is double insulated. An earth
connection is not required.
POWER SUPPLY
Remove the stereo carefully from the box, retaining the packaging for future
use (servicing).
AC POWER OPERATION
Connect the AC plug of the cable (6) to a mains power inlet 230V AC ~ 50 Hz.
AM/FM RADIO
OPERATION
•
Select the desired frequency band (AM or FM) with the Band Selector
(20).
•
Tune to the desired radio station by turning the Tuning control (7).
•
Turn the Volume control knob (8) to the desired level
•
To turn off the unit set the Function Selector (2) to the OFF position.
ANTENNA
•
For FM reception there is a built-in telescopic FM antenna (4) at the rear
of the unit. Extend the antenna and move it around to obtain the best
reception.
•
For MW reception the signals are picked up through a built-in ferrite
antenna. Your may have to orient the unit to obtain the best reception.
I
PLAYING MP3 FILES THROUGH SD CARD READER OR USB PORT
1. Slide the FUNCTION switch (2) to USB/SD position
2. Insert your SD card into the SD Card Reader (9) on the unit or plug in
your USB device to the USB slot on the unit (10).
3. The unit will start reading the MP3 files in the device and will start
playing the first MP3 files after reading.
4. Press the SKIP + button (12) to skip to the next track.
5. Press the SKIP - button (13) to go back to the previous track.
6. Press the FOLDER UP button 16) to go to the next folder.
7. While you are playing the device in the USB slot, if you insert the SD
card into the SD card reader, the unit will start playing the MP3 files in
the SD card and vice versa.
8. Press the PLAY/PAUSE button (11) to temporarily stop playing and
press the PLAY/PAUSE button again to resume playing.
9. Press the MODE button (18) to select the PLAY mode in the following
sequence: Repeat ONE, Repeat ALL or Normal Play.
English
3
Note :
While the unit is playing the MP3 files in the storage device thru the USB
slot, insert the SD card into the SD card reader will stop playing the MP3
files in the storage device thru the USB, the unit will start playing the MP3
files in the SD card. Removing the SD card from the SD card reader, the
unit will resume playing the MP3 files in the storage device thru the USB
slot...
AUX-IN CONNECTION
1. Slide the FUNCTION switch (2) to AUX position..
2. Insert one side of the audio cable (requires 3.5mm stereo plug, not
3. Turn on your audio MP3 player or audio device and follow its playback
4. To turn off this function, simply turned off your MP3 player.
SPECIFICATIONS
Power Supply
AC:
Battery:
Radio Frequency Coverage
FM:
MW:
Design and specifications are subject to change without notice.
4
English
supplied) into the line-out jack or phones jack on your MP3 player or
audio device and the other side to the aux-in jack on the unit.
instructions.
230V ~ 50Hz
6 x UM2
87.5 - 108MHz
530 - 1600kHz
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
This marking shown on the product or its literature, indicates that it
should not be disposed with other household wastes at the end of its
working life. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, please separate this from
other types of wastes and recycle it responsibly to promote the
sustainable reuse of material resources.
Household users should contact either the retailer where they
purchased this product, or their local government office, for details of
where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract. This product should not be mixed
with other commercial wastes for disposal.