Remove on the base (16) the 4 screws (15) fixing the tube as well as the 4 nuts (18) fixing
the counterweight.
Insert the tube (13) into the hole in the center of the base (16) and tighten the 4 screws (15).
Tighten the screws carefully to avoid damaging the appliance. Then install the decorative
cover (14) on the tube (13) to hide the screws.
Install the counterweight (17) and tighten the 4 nuts (18).
Adjust the tube (11) to the desired height and secure it with the screw (12) by tightening it
clockwise.
Loosen the fan head mounting screw on the back of the control panel (8) by turning it
counterclockwise, install the motor block (7) and control panel (8) on the extensible tube (11)
and carefully tighten the screw clockwise.
Place the rear grille (6) on the motor block (7) by taking care to align the notches in the grille
and put the handle at the top then tighten the locking nut on the rear grille (5) clockwise.
Place the blade (4) on the axis of the motor block (7) by taking care to align the slot of the
blade with the pin of the shaft and insert the blade until it locks in place.
Then tighten the blade locking nut (3) by turning it counterclockwise. Take care to tighten the
nut properly. Check that the blade rotates well by turning it manually.
Place the front grille (1) on the rear grille (6) and assemble the grilles using the grilles locking
ring (2) by tightening the nut and the ring screw. Take care to tighten the screw properly for
optimum safety.
5. OPERATING INSTRUCTIONS
WARNING : Before using your appliance, carefully read the safety instructions in this
manual.
Plug in the power cord.
Using the control panel or the remote control :
ON/OFF
Press the ON/OFF button to turn on and turn off the fan. The fan starts at low speed.
The SPEED 1 indicator is displayed on the screen.
Speed
Press the speed button to adjust the speed.
SPEED 1 - Low speed
ON/OFF button
Mode setting button
Timer setting button
Speed setting button
SPEED 2 - Medium speed
SPEED 3 - High speed
14