Temperature Regulation; Coolmatic Function; Frostmatic Function - AEG SANTO K 9 12 43-6i Notice D'utilisation

• During temperature adjusting operation, the temperature indicator shows the fridge
temperature currently set (DESIRED temperature). The DESIRED temperature is indicated
by flashing numbers.

Temperature regulation

To operate the appliance, proceed as follows:
1. Set the required temperature by pressing the corresponding temperature regulator. The
temperature indicator will immediately show the changed setting (DESIRED tempera-
ture) and the temperature indicator flashes.
2. Each time the temperature regulator is pressed the DESIRED temperature is adjusted
by 1 °C. The DESIRED temperature must be reached within 24 hours.
3. Once the required temperature has been set, after a short period (approx. 5 sec.) the
temperature indicator will show again the current ACTUAL temperature inside the cor-
responding compartment. The temperature indicator will change from flashing to con-
tinuous illumination.
For a correct storage of the food the following temperature should be set:
• +5 °C in the fridge
When the setting is changed, the compressor does not start immediately if automatic
defrosting is currently taking place. As the storage temperature within the fridge is reached
quickly you can store food immediately after switching on.

COOLMATIC function

The COOLMATIC function is suitable for quick cooling of large quantities of goods in the
refrigerator.
To activate the function, do these steps:
1. Press the COOLMATIC switch.
2. The COOLMATIC indicator will light up.
3. A DESIRED temperature setting of +2°C is automatically selected.
To deactivate the function, do these steps:
1. Press the COOLMATIC switch.
2. The COOLMATIC indicator goes out.
The COOLMATIC function stops automatically after about 6 hours.
If the COOLMATIC function is switched on the temperature setting may not be changed.

FROSTMATIC function

The FROSTMATIC function accelerates the freezing of fresh food and, at the same time,
protects foodstuffs already stored from undesirable warming.
To activate the function, do these steps:
1. Press the FROSTMATIC switch.
2. The FROSTMATIC indicator will light up.
To deactivate the function, do these steps:
1. Press the FROSTMATIC switch.
2. The FROSTMATIC indicator goes out.
The FROSTMATIC function stops automatically after about 48 hours.
35
Control panel