WARNING:
1.CHOKING HAZARD—Small parts. Not for children under 3 years.
2.Only allowed for adults to install, keep children away.
3.To be used under the direct supervision of an adult.
4.Just only allow one child to use.
5.Please use o
roadways, alleys, swimming pool areas, road, on grass or wet surfaces or other
bodies of water.
6.Before driving toy car each time, adult should inspect screws of every parts, please
tighten the screw cap if any looseness. secure all fasteners before every ride.
7.Always wear shoes and suitable protective equipment. always wear a local standard
approved helmet while riding, with the chinstrap securely fastened.
8.Do not ride the product at dusk, at night or at times of limited visibility.
9.Always comply with local laws and regulations.
MAINTENANCE & CARE
A. Keep all instructions and parts relating to this product for future reference.
B. Regularly check for damage and that all screws are securely tightened.
C. Check that the seat is securely fastened.
D. Lubricate the chain as often as required.
E. Regularly check tyre pressures.
Turn the body over and remove the connecting pieces.
1. Place the connector on the steering bracket. Pay attention to the plane and convex
surfaces of the connecting pieces in this step, with the plane facing upwards. The
convex surface is used to limit the steering Angle of the steering bracket.
2-3.Secure with M5*12mm & M5 nut the Steering connection plate.
at and clean surface. Never use near steps, sloped driveways, hills
1.Attach the Steering connection plate
2
1
3
2