ledscom LC-EL-056-WW Instructions De Montage page 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Remove the light from the mounting ring
(1). Loosen the screws (2) on the back of
the light and remove the light cover (3).
3. If necessary, mount the installation ring
(1). The mounting ring should be aligned
according to the illustration.
4. Poke a hole in one of the two rubber
seals (4). Guide the building-side
connection cable (8 - 10 mm cable
diameter) through the cable opening that
has now been created.
5. Connect the building-side connection
cable to the luster terminal inside the
luminaire as shown in Figure 2.
6. Now close the lamp housing again.
Then tighten the locking sleeves (6) hand-
tight.
7. Proceed with any cable output in
accordance with the cable input.
8. Then place the luminaire in the
mounting surface provided. The springs (6)
on the side of the light should now fix the
light in place.
9. Turn the power back on. The installation
is completed.
Subject to technical changes
English
Figure 1
1: Installation ring
2: Screws
3: Luminaire cover
Figure 2
Staircase light (LC-EL-056-WW) - Assembly instructions
4: Rubber seal
5: Springs
6: Locking sleeves
07/2024