Publicité
Les langues disponibles
Les langues disponibles
Caution:
When you are using the product, please make
sure all of the steam tubes are not bent as
shown in the picture since it would block the
flow of steam.
As results, the steam tubes may pop off and
the hot steam may stray out, causing scalding
and other bodily injuries. Make sure the steam
tubes are placed straight. If you find they are
bent, turn off the power and let them
thoroughly cool down first before you adjust
their positions.
Button Introduction
a).Switch Button (ON/OFF Button)
Press this button to switch between standby and operating status.
b).Timing Button (TIMER Button)
Press this button to shorten and prolong timer. 9-level timing settings:
(15, 20, 30, 40, 50, 60, 70, 80, and 90 min). Suggested time is 20-30
minutes.
c).Temperature Button (TEMP Button)
Press this button to increase temp. There are 9 grades. Suggested
temperature grade is 6-8.
d).Fogging Button
Photocatalyst fogging function makes steam have better wettability
and skin-friendly properties. At the same time, the steamer has a
certain bactericidal affect.
NOTE:
1.Do not operate without water in the steamer when the power is on.
2.Pay attention to the battery(not included). If there is not enough
battery left of the remote controller, please open the cover of the
battery behind the controller and install a new one, then close the
cover again.
10
Steamer Operation Instructions
1.Zip up the cover and add water to the steamer until the water
reaches to the M water line. This amount of water could last about 1
hour. If you like, you can add some herb or flowers in the steamer or
the steam box. Remember to use a gauzebag to wrap them in
advance.
2.Connect the steamer or the sauna room with shorter steamer hose
(Please keep the air in good conditions).
3.Make sure the lid is closed on the steamer and connect to the
power. Before connection, please note that the voltage on the power
plug is consistent with the voltage on the nameplate, and then press
the power button "ON /OFF".
4.Press the button on the steamer or use the remote to turn it on
and adjust the time to 90 mintues and temperature to P9. Let it
preheat for about 10-15 minutes first. When the steam is ready in
the tent, we will start the sauna.
5.Before you get into the sauna room, adjust the temperature back
to P6 first. Since the P6 is suitable for most people.You can turn it up
if you think it is not hot enough.
6.For time setting, press the "TIMER" button. There are 9 grades of
time from 15 minutes to 90 minutes. The recommended time is
20-30 minutes (press the up button for 15-80 minutes. For 90
minutes, the user has to press the button down).
7.For the temperature setting, press the "TEMP" button. There are 9
adjustable temperature grades. The recommended temperature is
6-8 grades depending on comfort level.
Press the up button to increase the temperature level from low to
high (1-2-3-4-5-6-7-8-9), which can be adjusted in a cycle. Press the
downward button, the temperature level decreases from high to low
(9-8-7-6-5-4-3-2-1), which can be adjusted in a cycle.
8.There is a "FOGGING" button. When pressed, the water vapor
becomes smoother and more pleasing to the skin.
11
Publicité
