JBM 53872 Guide D'utilisation page 3

REF.53872
EN
INSTRUCTION MANUAL
Please read these operating instructions carefully and
note the information given. Use these operating instruc-
tions to familiarize yourself with the product, the proper
use and the safety instructions.
INSTALLATION
1. Take out the unit and accessories from the box.
2. Choose a suitable place near source of water or air..
3. Take the mounting bracket as a template to mark the
position for screws and drill four holes on the wall( Fig.2)
4. Fix the bracket by four self-tapping screws accordingly,
(Fig.1)
5. Connect the reel to the mounting bracket.
Note:
1. The reel should be installed to a wall or post hori-
zontally.
PART LIST
NUM DESCRIPTION
1 Hose reel
2 Mounting bracket
3 Self-tapping screws
TROUBLESHOOTING
DEFAULT
The hose could not
retract
QTY
1
1
4
REASON
Pull out all the hose,then it
is locked, and left no more
length to unlock
Spring is fatigued
2. It is suggested to mount the reel approximately 1
meter above the ground.
OPERATION
Connect the leader hose to the air source, then turn on the
switch.
Unwind
Pull out hose to desired length and stop.
Roll up the hose
With the end of the hose, go back to the Hose Box.
Turn off the air source, loosen the connector of lead hose.
STORAGE
Cleaning
The hose box is maintenance-free and must not be cleaned
internally with water.
MAINTENANCE
• When not in use, please turn off the source of water/air,
and turn on the nozzle to release the pressure
• The reel cannot not be used to transmit any chemical
and substance
• When not in use for an extended period of time it is re-
commended to be stored in a cool dry place.
SOLUTION
Go through the window to turn the reel for half a turn in
the direction of hose being pulled out.
Please re-preload the spring for 1-2 turns: remove the
small cover, use spanner to clamp the groove of preload
wheel, unscrew four bolts on the wheel, then rotate it for
1-2 turns in clockwise, then fasten the bolts, and replace
the cover.Fig.4
· 3 ·