Publicité
Les langues disponibles
Les langues disponibles
GENERAL INFORMATION
This remote controller is desianed to separatelv control vour ceilina fan speed and light on and off.
There are four buttons(HI,MED, LoW,OFF) to control the speed of the fan and off.
The light button will control the light on and off.
The red indicator on the transmitter will light when one of the five buttons is pressed.
INSTRUCTION OF INSTALLATIONAND OPERATION
1.SETTING THE CODES
To set the codes, perform the following steps:
A.Setting the codes on the transmitter:
a.Remove battery cover.Press firmly on the arrow and slide battery cover off.
b.Slide code switches to your choice of up or down position.(Factory setting is all up. Do not use this position.Use a
Small screwdriver or ball point pen to slide firmly up or down .
B.Setting the codes on the receiver:
The Learn Key must be pressed with in 30 seconds, after pressing the Power button.
If not, please press the Power button to restart.
Keep pressing the button learn key in excess of 3 second it becomes a LEARN status.
The receiver can r
emember the last codes status. The light flash two times.
2.INSTALLING RECEIVER IN CEILING FAN
A.Safety precautions:
WARNING: HIGH VOLTAGE! Disconnect power by
removing fuse or switching off circuit breaker.
Do not use with solid state fans.
Electrical wire must meet all local and national
electrical code requirements.
Supply for fan must be 110/120 volt, 60Hz. Maximum
fan motor amps: 1.0,Maximum light watts: 180
incandescent or ballast and LED.
Otherwise power can cause serious injury or death.
B.lnstalling receiver in fan:
a.Remove power from the circuit.
b.Remove ceiling fan canopy from the mounting
bracket.
c.Disconnect existing wiring between ceiling fan and
Supply in electrical junction box.
d. Make connections as follows, using the wire nuts
supplied:
OP ERATING TRANSMITTER:
A.Install CR2025 volt battery.
(To prevent d am age to transmitter, r em ove the battery if not used for a long time).
B.Store the transm itter away from excessive heat or humidity.
C. Operating the buttons on the panel of the transmitter.
ting the codes on the rec eiver:
1.
Code matching key: The operation is as follows: press this key to code matching within 5 seconds
after the fan lamp is powered on. If the code matching is successful, the fan will make a "drop"
sound; if not, repeat the action.
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Remote controller
Fan speed 1
Fan stop
STOP
on/off
I
Light on/off
Installation & Operating Instructions for the
Parrotuncle Owner's Installation ,Manual
Fan speed 2
Fan speed 3
1.
Foward/Reve rse
2.Code matching key
F8258110V
Publicité
