ledscom LC-L-008-WW Instructions De Montage page 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. To connect, open the light by
unscrewing the housing (1) as shown in
"Figure 1". Then carefully lay the housing
(1) aside so that it cannot be damaged.
3. Drill two holes (10 mm Ø) in the floor
and insert the supplied dowels (7) there.
The positioning of the holes should
correspond to that of the screw holes (3).
Make sure that the dowels (7) are flush
with the floor.
4. Guide the power supply line through the
cable opening (2).
5. Open the strain relief bracket (4) and
connect the wires of the cable according to
"Figure 2". Fix the cable using the strain
relief (4).
6. Fasten the light with the screws (6) and
washers (5) provided.
7. Close the light by screwing the housing
(1) of the light shut.
8. Turn the power back on. The installation
is now complete.
Subject to technical changes
English
Figure 1
1: Housing
2: Cable opening
3: Screw holes
4: Strain relief
Figure 2
Path light (LC-L-008-WW) - Assembly instructions
5: Washer
6: Screws
7: Dowel
07/2024