YATO YT-82961 Mode D'emploi page 7

EN
PRODUCT CHARACTERISTICS
The lamp is designed to illuminate the workplace. The battery power supply makes the lamp a highly mobile device. The lamp is
equipped with its own base, as well as a hook for suspending the lamp. The light source is a powerful LED. Proper, reliable and
safe operation of the product depends on appropriate use, that is why you should:
Read and keep the entire manual before the fi rst use of the product.
The supplier shall not be held liable for any damage or injury resulting from improper use of the device, failure to observe the
safety regulations and recommendations of this manual. Use of the device for purposes other than those for which it was intended
shall cause the loss of the user's rights to a warranty and under statutory warranty.
ACCESSORIES
The battery and charging station are not included.
SAFETY INSTRUCTIONS
Do not use the lamp in fl ammable and potentially explosive atmospheres, e.g., near drying fl ammable paint, fuel or solvent
vapours. Sparks inside the product may cause vapour ignition which could lead to fi re risk, explosion hazard and cause serious
injury.
Do not leave the device connected to the power supply unattended.
The device is intended for indoor use only.
Do not clean the device using a jet of water or any other liquid. Do not immerse the device in water or any other liquid. Do not allow
water or any other liquid to enter the lamp.
Do not cover the device while it is operating. This can cause the device to overheat and damage, as well as cause fi re.
The housing has a non-replaceable glass and in case of damage or breakage of the protective glass, the entire lamp should be
replaced immediately. The housing must not be used without the protective glass or with damaged protective glass!
The electrical wiring system powering the lamp should be effi cient, periodically checked, with properly selected fuses and should
provide protection against electric shock through quick shutdown.
Never use a lamp with visible mechanical damage, broken lamp glass, or other visible damage.
Do not touch the lamp housing, as it becomes hot during operation and may cause burns.
DEVICE OPERATION
Preparing for operation
Only the following 18V Li-Ion YATO batteries can be used to power the device: YT-82842, YT-82843, YT-82844 and YT-82845,
which can only be charged with YATO YT-82848 or YT-82849 chargers. It is forbidden to use other batteries with a diff erent rated
voltage and not matching the device battery socket. It is forbidden to modify the socket or battery to make them match.
Warning! If the device is to be powered by the battery, it is required to disconnect the power supply plug from the device.
Slide the charged battery into the guides of the battery socket so that the battery latch holds it in place. Check whether the battery
does not slide out of the device socket by itself.
You can also use the included power adapter for power. The power supply socket is located on the bottom of the refl ector housing
and is protected by a cover. The plug of the power supply cable should be connected to the socket, and the power supply itself
to the mains socket.
Lamp operation
Press the power switch to turn on the lamp. Pressing the switch again changes the illumination mode, and the next press turns
off the lamp.
Warning! Do not look at the lamp's light source when switching it on or when the lamp is operating. A strong luminous fl ux can
cause temporary or permanent eye damage.
The lamp housing inclination is adjustable. To change it, loosen two lock knobs by unscrewing them slightly. Set the lamp housing
in a selected position, then lock it by tightening both knobs.
Warning! For safety reasons, the inclination should be adjusted with the disconnected power supply. The battery must be discon-
nected from the device.
The base includes a hook which can be used to suspend the device. Make sure that the suspended lamp will not fall by itself. The
suspension point must withstand the load of the lamp together with the battery.
O R I G I N A L I N S T R U C T I O N S
7