Natec RIBERA GAN Mode D'emploi page 3

USER'S GUIDE
EN
NATEC RIBERA GAN
SPECIFICATION
Input
Output*
Maximum power
Protection
*Please refer to the Power schematics on the first page for actual power outputs, depending on the number
of connected devices.
CAUTION!
• Before using the device, read the user manual and follow the instructions. The manufacturer is not responsible for
damage caused by the use of the device contrary to its intended use, improper operation or repair by unauthorized
personnel.
• The charger is suitable for 110-240V mains voltage, which allows its use worldwide.
• Before use, make sure that the end device can be powered by the output power of the charger.
• Follow the instruction manual of the device being charged.
• Note that the end device must support fast charging technology (Power Delivery) for the charging process to be
efficient and optimal.
• Since there are many devices on the market with PD function and different software versions installed, it may
happen that this function is not supported completely.
• The charger should be plugged into an outlet with a voltage compatible with its specifications.
• Before each use, check the charger for signs of external damage. In case of damage, do not use the device.
• The charger is designed for use in areas at an altitude of 2000 meters and below.
INSTALLATION
1. Plug the charger into a properly installed and easily accessible power outlet.
2. Connect the terminal device to a USB outlet using a suitable charging cable.
3. Disconnect the end device from the charger to stop charging or when the end device is fully charged.
4. Disconnect the charger from the power source.
SAFETY INFORMATION
• The product should not be used to charge any other device other than the one it is designed for.
• The charger is designed for indoor use only. Do not expose the device to the weather.
• Protect the charger from heat and humidity (including during storage).
• Do not use the charger on flammable surfaces that impede ventilation.
• Flooding / getting it wet may lead to a short circuit and electric shock.
• Do not insert any objects through the gaps in the housing. This risks short-circuiting the components, with the risk of fire
and electric shock.
• Do not open or repair the charger or perform maintenance work. Unauthorized repair or disassembly will void the warranty
and may result in damage to the device, with the risk of electric shock.
• Dropping or bumping may cause damage, scratching the case or other product malfunction.
• The product is not intended for use by children or persons with limited physical, sensory or mental abilities. Use only under
the supervision of a parent or legal guardian responsible for safety.
• Keep the charger out of the reach of children.
• If you find that the device is hot, immediately unplug it from the mains and let it cool down.
• In the specific case of a fire, it is unacceptable to extinguish a live device with water, as there is a risk of electric shock or
death. Unplug the charger from the power outlet if it is safe to do so, or cut off the power supply. Extinguish electrical
devices with an approved powder extinguisher at a safe distance.
110V – 240V 50/60 Hz 2 A Max
USB-C1/C2/C3: 5/9/12/15V⎓3A, 20V⎓5A (100W Max)
USB-A: 5/9V⎓3A, 12V⎓2.5A (30W Max)
100 W
OV/OC/SC/OT