Publicité
Les langues disponibles
Les langues disponibles
LOADING LABELS
1.
Push the release button and swing the cover open
completely. You should hear a click. (See Figure 1)
NOTE: Do not force the cover past the click position.
2. For loading a new roll of labels, tear off and discard
the first 10 inches of label and liner.
3. Peel the first 12 labels from liner and discard.
4. Place the label roll between the hubs and click
into place. (See Figure 4)
NOTE: Do not thread label strip through any rollers.
HUBS
Figure 4
5. Drape the supply across the labeler and center it
over the peel bar. The supply should hang out 6-7
inches past the peel bar.
6. Close the cover.
7.
Squeeze and hold the trigger while feeding the label
strip under the roller and into the large slot above the
arrow until it stops/hits the back. (See Figure 5)
Figure 5
8. Hold the strip in place and squeeze the trigger eight
times or until the label strip feeds through the rear exit.
9. Remove any loose labels.
PAGE 2 OF 9
INSTRUCTIONS CONTINUED
CLEARING LABEL JAMS, CLEANING
AND LUBRICATION
1. Open the cover and remove the label roll.
2. Remove any loose labels from the inside of the
PEEL
3. Pull up on the supply guide to expose the backing
BARS
4. Snap the supply guide back into place.
5. Use a commercial adhesive solvent to clean
6. Remove the ink roller to expose the print bands and
7.
labeler. (See Figure 6)
Figure 6
LOOK
HERE
paper path and remove loose labels. (See Figure 7)
LOOK
HERE
adhesive buildup.
brush them off with a toothbrush.
Reload, then close the cover.
LOOK
HERE
SUPPLY
GUIDE
Figure 7
Apply 1 drop of a commercial
100% silicone lubricant here.
0324 IH-993
Publicité
