Twin-Star International DFS-760-1 Manuel D'instruction page 6

OPERATING INSTRUCTIONS
TO ACCESS CONTROL PANEL - Remove the lid located on the top of the stove.
MAIN POWER
The power switch supplies power to all of the functions of the fireplace.
HEATER
Your fireplace consists of a fan-forced wire-element-type heater. The heater switch turns the heater
ON and OFF. The temperature switch controls the thermostat feature to help regulate the room's
temperature accordingly. As an important safety feature, the heating element is designed with a
delayed activation sequence. When the heater is turned ON it will take several seconds for the unit
to begin blowing hot air and the fan blower will continue to run for several seconds after the heater is
switched OFF.
TEMPERATURE
The temperature control knob regulates the temperature level of the heater. Turning the knob
clockwise will increase the heat output. The further the knob is rotated clockwise, the higher the
set point temperature. Turning the knob counterclockwise will lower the set point temperature.
Use this function to help regulate the ambient temperature level.
FLAME
The flame brightness control knob adjusts the flame brightness. Turning the knob to the left
(counterclockwise) dims the lights and flame effect. Turning the knob to the right brightens the lights
and flame effect.
NOTE: This equipment has been tested and found to comply with the limits for
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
All manuals and user guides at all-guides.com
Fig. 4
E-5
TEMPERATURE HEATER FLAME
ELECTRIC FIREPLACE REMOTE
MAIN POWER
POWER
FLAME
HEATER
Fig. 5