Vechline Visio Evo EASY Manuel D'utilisation page 4

GB
1. Introduction
VISIO EVO EASY is a reverse camera system designed for motorhomes.
Our products have been manufactured for your full satisfaction. Our liability commitment ensures many
years of your vehicle's integrity.
We advise you to have this product installed by a professional; we also advise you to read carefully
this guide for an optimal use of this product.
2. Safety Information
Before mounting the video system, disconnect all the batteries of your vehicle.
During the installation, avoid causing short circuits between all standard equipments of the vehicle.
Read carefully and follow the safety instructions from your vehicle's manufacturer.
The screen must be placed in a way that it will not interfere with the trigger action of the air bag.
The screen must be installed in a fixed place in case of sudden stop of the vehicle.
3. Before installing
Please follow carefully these instructions prior to the installation:
Make sure that your vehicle is equipped with a 12 or 24 volts battery ; screen power supply.
Check if all electric functions of your vehicle are working well, such as indicators, brake lights, horn, ignition, lights.... Make sure all these
functions are still working well after the mounting.
Find wire negative and positive terminals by using a voltmeter.
4. Technical Specifications
Screen operating voltage :
Screen size :
Brightness:
Heating function :
Vibration resistance
Screen weight :
Camera Viewing angle :
Camera weight :
5. Installation Tips
Do not install the screen in the driver's field of view.
Reeve the cable into the vehicle. If not possible use a fixing system and protect the cable in order to avoid any damage.
To provide a suitable viewing angle, the camera must be fixed at a minimum height of 2m.
Before drilling (a 15 mm hole) check that there is no risk of damaging any component inside the vehicle behind the panel.
Make sure the cables are not close to sharp edges or objects
without protection.
Insulate all electrical supplies you need for the installation.
After drilling the hole for the cable, start sealing through-holes
with a suitable sealant.
Do not install the camera on the roof (tree branches could
damage the camera) but at the back of the vehicle.
Do not clean the camera with a high-pressure water cleaner.
Do not open the camera, as this may damage its waterproof
properties and functioning.
Do not pull on the cables, as this may damage its waterproof
properties and functioning.
Do not immerse the camera into water.
6. Remote control
Camera selection
Down (-)
Mode selection
12/24 VDC
7'', 16/9
400 cd/ sqm
Yes
: 10G
800g
120°
350g
ON / OFF
Up (-)
Replace the battery (CR0205) as soon as
the remote control is weakening.
Menu
Do not drop nor step on.
Do not use next to water.
Screen power :
Video system :
Audio :
Operating temperature:
Screen size(LxWxH):
Camera operating voltage :
Night vision / range :
Cable length :
Inside
Camera
cable
4
4 W
NTSC/PAL
Yes
-20 / 50°C
250x108x23mm
12 VDC
18 infra red LED / 15m
18m
Outside
45° downward hole
to avoid infiltrations
Camera
2 1