Publicité
Les langues disponibles
Les langues disponibles
12
12C
12A
12B
12 PULL-OUT HOSE ATTACHMENT
From underneath sink, push Quick Connector (12A), located on the end of the Pull-Out
Hose (12B) firmly upward onto the Receiving Tube (12C), until unable to push any
further. Pull down on the Quick Connector (12A). If the housing and the Inner Collet
(12D) separate slightly but do not pull off the Receiving Tube (12C), quick connect is
secure.
13
13 SOAP DISPENSER INSTALLATION
From above sink, insert threaded Shank (13A) of soap dispenser body through Foam
Gasket (13B) and sink hole. From below sink, tighten Nut (13C) and thread on Soap
Bottle (13D) to Shank (13A).
12D
12C
12A
12A
13A
13B
13C
13D
ENGLISH
14
14 SOAP DISPENSER HEAD INSTALLATION
Pour liquid soap (not included) into the Soap Dispenser Body (14A). Insert Pump
Mechanism (14B) into Soap Dispenser Body (14A). Install Dispenser Head (14C) by
pushing firmly onto Pump Mechanism (14B).
15
15C
15B
15A
HOT
15 WATER SUPPLY CONNECTIONS
Gently separate hot and cold Faucet Inlets (15B), approximately three inches apart.
Connect water Supply Lines (15A) to Faucet Inlets (15B). Hot water supply line goes
to hot inlet fitting indicated by red tag (15C). (Supply lines not included). Follow
manufacturer's instructions when installing supply lines.
16
16B
16 SECURING INLET LINES
Do not cross Pull-Out Hose Connection (16A) with Inlet Supply Tubes (16B) to avoid
binding, jamming and interference with the movement of the Pull-Out Hose (16A).
4
14C
14B
14A
15B
15A
COLD
16B
16A
Publicité
