Delta 50-764 Manuel D'utilisation page 12

ATTACHING TOP FILTER BAGS
DISCONNECT MACHINE FROM POWER
SOURCE
NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP.
1. Assemble upper (A) and lower (B) bag hanging rods
as shown in Fig. 11.
2. Place large O.D. 5/16" flat washer on 5/16"x1-1/2"
hex head screw. Insert the screw through hole in
center of bag hanging assembly (A) Fig. 12 and Fig.
12A and through the hole in the upper bag hang-
ing rod (B) Fig. 12. Then place another large 5/16"
flat washer on end of screw followed by a 5/16" lock
nut. Assembly shown complete in Fig. 12. Tighten all
securely with 12mm wrench.
3. Hang bag loops (C) Fig. 12A around hooks on bag
hanging assembly (B), as shown in Fig. 12A
4. Insert rod (A) Fig. 12B into hole in bracket (B). Make
sure the four bag ends are not twisted.
5. Work open end of filter bag into top groove of dust
collector drum until secure and sealed. (Similar to
how internal ring of bottom bag was inserted, Fig. 9.
It will be necessary to bend and fold the internal bag
retainer ring to fit it into place.
6. Fig. 12C shows the bags installed properly.
7. Repeat steps for the other bag.
Fig. 12C
B
12-English
A
B
Fig. 11
Fig. 12
A
C
Fig. 12A
A
B
Fig. 12B
A
B