Uline JIFFY J-4000 Guide Rapide

π
H-4474
JIFFY J-4000
®
COMMERCIAL
GARMENT STEAMER
TOOL INCLUDED
Wrench
TO USE
1. Attach hose with wrench or spanner.
2. Fill with one gallon (3.79 liters) of hot tap water.
NOTE: Cold water takes longer to preheat.
NOTE: Use enclosed funnel when filling.
NOTE: Never have more than one gallon
(3.79 liters) of water in the steamer at any time.
3. Plug into wall or base receptacle and turn switch
to PREHEAT position. Steamer will preheat to 200°F
(93°C) and the preheat thermostat will hold the
unit at this temperature. Light will go on and off
periodically.
FOR STEAM
1. Turn switch to STEAM position. Ready for use in two
minutes (after water is preheated).
NOTE: When finished steaming, turn switch
back to PREHEAT or OFF position.
NOTE: If the steamer runs dry, it will temporarily
shut off. Allow the unit to cool before adding
water.
NOTE: Steam may be applied from either the
inside or outside of fabrics.
PAGE 1 OF 3
1-800-295-5510
uline.com
OPERATION
FOR BEST RESULTS
• Straighten hose up and out frequently to keep clear
of condensation.
• Always hang hose upright when not in use.
• Rinse steamer out approximately every two weeks or
when sediment appears in the bottom of the sight
gauge.
• Flush steamer regularly with cleaner to prevent
sediment buildup.
• Unplug when not in use.
• For indoor use only.
• Do not run dry.
• Contact Uline Customer Service at 1-800-295-5510
for additional product information or instructions.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0424 IH-4474