Publicité
Les langues disponibles
Les langues disponibles
SLI300.2 / SLI500.2 - Low impedance stereo class D amplifiers
4 - Operating modes
4-1 - Stereo mode
CHANNEL A
LINK A
INPUT A
The stereo signal is injected into INPUT A and INPUT B inputs. Each channel is independent.
Minimum impedance for each output is 4 Ohms.
Channel A is available on terminals 1+ and 1- of OUT A.
Channel B is available on terminals 1+ and 1- of output OUT B, but also on terminals 2+ and 2- of output OUT
A.
4-2 - Parallel mode
CHANNEL A
LINK A
INPUT A
INPUT B
Ou
Mixing console
A signal is injected into INPUT A or INPUT B.
This signal is amplified by the two power channels A and B separately.
Level control is via the VOL A or VOL B potentiometer.
Minimum impedance for each output is 4 Ohms.
CHANNEL B
MODE
Stereo
Parallel
Bridge
Mute
INPUT B
LINK B
Mixing console
CHANNEL B
MODE
Stereo
Parallel
Bridge
Mute
LINK B
OUT A
OUT B
CH A
1+ 1-
MADE IN CHINA
CH B
DISTRIBUTED
2+ 2-
BY HITMUSIC S.A.S
BRIDGE
1+ 2+
Minimum impedance:
4 Ohms
OUT A
OUT B
CH A
1+ 1-
MADE IN CHINA
CH B
DISTRIBUTED
2+ 2-
BY HITMUSIC S.A.S
BRIDGE
1+ 2+
Minimum impedance:
4 Ohms
CH B
1+ 1-
WARNING
CAUTION
DO NOT EXPOSE
FOR CONTINUED PROTECTION
THIS EQUIPMENT TO
AGAINST RISK OF FIRE, REPLACE
RAIN OR MOISTURE
ONLY WITH THE SAME TYPE OF FUSE
ATTENTION
ATTENTION
RISQUE DE CHOC
UTILISEZ UN FUSIBLE
ELECTRIQUE
DE RECHANGE
NE PAS OUVRIR
DE MEME TYPE
Use only with a 250V fuse
Minimum impedance:
4 Ohms
CH B
1+ 1-
WARNING
CAUTION
DO NOT EXPOSE
FOR CONTINUED PROTECTION
THIS EQUIPMENT TO
AGAINST RISK OF FIRE, REPLACE
RAIN OR MOISTURE
ONLY WITH THE SAME TYPE OF FUSE
ATTENTION
ATTENTION
RISQUE DE CHOC
UTILISEZ UN FUSIBLE
ELECTRIQUE
DE RECHANGE
NE PAS OUVRIR
DE MEME TYPE
Use only with a 250V fuse
Minimum impedance:
4 Ohms
English
Page 9
Publicité
