SPORTNOW A91-249V00 Mode D'emploi page 9

EN
H
A
K-2
N"
P
B
L
D
E
G
F
1.Pass the bolt (I) through the middle of the base (F) and the four holes on the connecting
piece (E), then fix it with the matching nut (I).
2.Install the suction cup (G) on the four sides of the bottom of the base (F), lock the nut (M)
with a wrench (J), then place it in the desired position.
3.Connect the four holes at the bottom of (D) with (E) and fix it with nuts (M).
4.Insert the upper section (C) into the cylindrical steel pipe (D), adjust the required position
and fix the height with the adjusting bolt (L).
5.Connect (n) with the adjusting rod (C), and fix (N") and (n) with (P).
6.Install the rotating rod (B) on the upper end of the adjusting rod (C).
7.Put the flat washer (O) and spring washer (Q) on the top of the adjusting rod (C), then lock
the nut at the lower end of the connecting spring (K).
8.Use the supplied pump (H) to inflate the balloon (A) with 4lbs, place the gasket (Q) on the
top of the spring (K), then lock it (A).
9.Install (Q), (K-1) and (Q) at the lower end of (N), then fix and lock with (A).
10.The rotation radius is 80cm. Keep away from obstacles and fragile objects.
Boxing is a contact sport, which could result in serious injury. When boxing, ensure you are
in good physical condition and under expert supervision. This equipment will provide limited
protection, however it will not completely prevent the risk of injury. Users must assume the
risk of any injury.
O
Q
C
C
N
O
K-1
A
M
I