REV Ritter FLOOD 30 Mode D'emploi page 10

GB
SAFETY INSTRUCTIONS FOR BATTERIES
• Do not attempt to revive batteries or rechargeable batteries by heating or similar measures. Primary batteries
must not be recharged as this can lead to electrolyte leakage, explosion or fire.
SCOPE OF DELIVERY
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• Product
• Instructions
• Power supply plug + 95cm USB cable
TECHNICAL DATA
Work lamp
• Output: 30W LED
• Illuminant: SMD LED´s
• Luminous flux: 3000lm
• Luminous efficacy: 100lm/W
• Colour temperature: 7000K
• Colour rendering index (Ra/CRI): ≥ 70
• Energy efficiency class: A+
• LED service life: 30.000h
• Beam angle: 120°
• IP protection class: IP54
• IP protection class (in charging state): IP20
• Protection class: III (S5)
• Ambient temperature: -10°C - 40°C
• Dimensions W x H x D: 240 x 231 x 160mm
• Weight: 1032g
• Battery: 3,7V / 8000mAh (4x2000mAh) /
Lithium polymer batteries (18650) / 29,6Wh
• USB: 5,0V DC, 1,0A
OPERATION
• Charging: Before (first) use, fully charge the product until the battery indicator lights up completely
• Charging time: 4,5 hours
• Running time: 2 hours (3000lm) / 4 hours (1500lm)
• 1x press: half power (1500lm)
• 2x press: full power (3000lm)
• 3x press: Off
CLEANING
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!
MAINTENANCE
• Replace any damaged protective panels immediately (S7).
• Remove all dirt from the housing or protective panel immediately, as this can lead to overheating.
• The light source of this luminaire is not replaceable; if the light source has reached the end of its service life, the
entire luminaire must be replaced.
10
Power supply unit (power supply plug in combination
with USB cable included in delivery)
• Input voltage: 230V~, 50Hz
• Output voltage: 5.0V DC
• Output current: 2.0A
• Power output (Po): 10.0W
• Average operational efficiency: 78.74%
• Efficiency at low load (10%): 74.24%
• Power consumption at no load: 0.055 W
• Protection class: II (S6)