Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
WATER REMOVAL
3. Pump Drain
If the continuous drain is inconvenient, water can be
removed from the appliance using the pump drain.
When using the pump, the appliance will first fill the
bucket with water and then the pump arm will pump
water from the bucket through the drain and out the
hose.
Remove the continuous drain hose from the unit and
rotate back plastic cover to the continuous drain
hose outlet clockwise.
Peel off the fixed tape, insert the pump drain hose
into the pump drain hose outlet for depth of 15 mm
at least, and make sure the hose is secure so there
are no leaks.
Direct the other end of the hose to a drain. Press the
pump button to activate the pump function. When
the bucket is full, the pump will begin to work.
Ensure that the drain hose is not bent, this can stop
the water from draining correctly and overwork the
pump.
Do not connect the provided hose together with
another hose. The maximum length of the pump
drain hose should be no more than 4.6 m (15 feet).
If the drain hose is too long water may not drain
completely which can lead to stagnant water and
mildew build up inside the hose.
When using the pump drain, the water bucket
should be emptied every few days to ensure that the
water in the bucket does not become stagnant or
grow mildew.
To remove the hose, press inward on the ring
around the drain and pull the hose outward.
Important: If the drain pump is activated, water will
exit the drain whether a hose is attached or not.
Ensure that the drain pump is deactivated when the
hose is removed to avoid damage to floor due to
leaking water.
13
Publicité
