Télécharger Imprimer la page

ims PRO CUTTER 45 CT Manuel D'utilisation page 22

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
No arc
-
Arc stops after 3 seconds of cutting
-
The machine does not switch on.
-
The pilot-arc cuts out too quickly
-
The arc stops mid-way through cutting
-
Premature wear of consumables
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
22
IMS CUTTER 45 CT
The electrode has not retracted or there
is not enough air coming out.
No current detection in the earth clamp
No power supply
Used consumables
cutting speed too low on thin sheets
Contact on the low-quality earth clamp
Cutting height too high
Cutting current inappropriate for consu-
mables used
Inappropriate air pressure
Humid air
EN
Check that the electrode is properly
retracted.
Check the pneumatic system (check
if the hose diameter too small or
hose too long, if the hose pinched or
kinked).
Check the size of the compressor.
Check that the earth clamp is connec-
ted to the cutting part on a clean area
(no rust, paint or grease).
Check that the power cord of the pro-
duct is plugged into the outlet and that
the power switch is in the on position.
Check that the circuit-breaker has not
tripped.
Check the condition of the consumables
and replace if necessary.
Reduce the current / increase the
movement speed.
Check that the earth clamp is connec-
ted to the cutting part on a clean area
(no rust, paint or grease).
Use a cutting pad and keep it in contact
with the part to be cut.
Refer to the chapter "Setting the cut-
ting current".
Refer to the chapter "Adjusting the air
pressure".
Purge the air filters from the station
and the compressed air network. Add
the additionnal Air filter ref. 039728.

Publicité

loading