GE XPIO43SCSS Manuel D'utilisation page 7

Care and Cleaning
To keep nugget ice tasting fresh and ice maker performing
Descaling is recommended for removing hard mineral
depending on water hardness.
Sanitizing
water, cleaning schedule may need to be adjusted based
on hardness of water.
switching to distilled water is suggested. To clean the
soft cloth dampened with soapy water to gently clean the
clean the reservoir. Use a soft cloth moistened with water.
System Descaling / Sanitizing Procedure
1. Unplug Opal.
4. Descaling:
instructions provided.
Sanitizing:
5. Pour solution into water reservoir, up to the fill line
figure 4. After three minutes the water will stop and
NOTE:
8. Descaling: run the clean cycle up to 3 times and
then let the unit sit for 18 hours and soak. While the
unit is soaking, dip a cloth in the solution and wipe
the inner walls. Use a cotton swab to clean any
cracks. When you are done, rinse the cloth with clean
water and wipe Opal again to remove any cleaning
deposits.
Sanitizing: once the Cleaning indicator turns off,
promptly drain the Opal.
49-9000058 Rev. 4
WARNING
cleaning with bleach, use bleach in a well ventilated area
WARNING
Unplug the product before cleaning by
hand, and when not in use.
Clean
Hold 3 Sec
Making Ice
Defrosting
Water
Light Power
Add Water
Cleaning
7