Télécharger Imprimer la page

HPA AM-1100 Mode D'emploi page 6

Publicité

Les langues disponibles

Les langues disponibles

All persons involved in the operation, installation and maintenance of this device
must be trained and qualified, and must comply with the following
instructions
Replace defective mains cables only by a specialist. Risk of electric shock!
If you're not sure of the correct connection, or if you have any questions
that aren't answered in the instructions, please ask a specialist or your dealer
for advice.
To avoid damage caused by power surges, unplug the adapter and switch off
the device if it is not to be used for a long time.
The device in operation must not be exposed to extreme temperatures (not below 5°C
and not above 35°C).
The device may only be used indoors.
Do not place an open flame such as a candle on or near the appliance.
Do not expose batteries to excessive heat such as sunshine, fire or the like.
When the power cord or a device coupler is used as a disconnecting device, this
device must remain easily accessible.
IMPORTANT NOTE: Electrical products must not be disposed of with household waste.
Please have them recycled where recycling centers exist. Consult your local authorities or your dealer about how
to
recycle them.
In compliance with CE standard requirements
Recycled products are recyclable
For indoor use only
FRONT CONTROL PANEL
1/ Switch ON / OFF
2/ Channel A/B output volume
3/ Channel A/B LED.
Clip: lights up when the input signal is too high and may cause distortion.
Signal: lights up when a signal in input A/B
6

Publicité

loading

Produits Connexes pour HPA AM-1100

Ce manuel est également adapté pour:

Am-1700Am-2400