Current EXO OUTDOOR LIGHTING SGF1 Instructions D'installation

INSTALLATION INSTRUCTIONS - SGF1 SLING FLOODLIGHT
WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes. Failure to do so may increase
the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and use so fixture failures do not cause a hazard and use only in
environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other reproductive harm. Thoroughly
wash hands after installing, handling, cleaning, or otherwise touching this product.
WARNING! Dangerous voltage exist within the unit and all precautions usually observed in handling high voltage equipment should be observed when
replacing light engine or otherwise servicing luminares. Disregarding this warning could result in electrical shock and possible injury to the individual
installing or servicing this equipment. Installation and servicing should be done by qualified personnel.
CAUTION! Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding luminaire operation and burning
position. Luminaire label shows electrical and environmental requirements and restrictions.
NOTE! This luminare is designed for outdoor lighting applications with ambient temperatures not exceeding 40°C (104°F).
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before installation or servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat retention. Dusting with a soft, clean,
dry cloth is normally sufficient for the optical system. Any accumulation of dust or dirt should be removed regularly.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any work, contact your distributor
or lightingtechsupport@currentlighting.com or (864) 678-1000
Give instructions to facility owner/manager for future reference.
Tools Required: 5mm hex key, pliers or channel locks.
This light fixture is supplied with a threaded knuckle for mounting
and aiming. The thread is 1/2-14 NPS. Use thread sealant. Once
mounted and aimed tighten the conduit nut with pliers or channel
locks. Use a 5mm hex key to loosen the screw shown below
enough to allow for fixture aiming. Once the desired aiming is
achieved tighten the screw.
Please note that this light fixture can not be opened because it
has a glass lens that is completely sealed to the housing with
adhesive.
READ THOROUGHLY BEFORE INSTALLATION
SAVE THESE INSTRUCTIONS
USE HEX KEY
ON THIS SCREW
SGF1