Publicité
Liens rapides
Publicité
Manuels Connexes pour STARLINK Volcano Mount
Sommaire des Matières pour STARLINK Volcano Mount
- Page 1 Starlink Volcano Mount...
- Page 2 The Starlink will detect and melt snow that falls directly on it; L’antenne Starlink détectera et fera fondre la neige qui tombe however, accumulating snow around the Starlink may block the directement sur sa surface, cependant, les accumulations de field of view.
- Page 3 SETUP Box Contents Sealing Wall Volcano Mount Carrying Bag Sealing Tape Bolts Clips Tape Strips Squares Additional Items Needed Stud Drill 5/32 in. 1/2 in. Finder Drill Bit Socket Wrench...
- Page 4 SETUP Find A Spot Clear view (100 degrees) of the northern sky over the perimeter of rooftop. Choose A Route Avoid placing the Starlink above livable areas. The Starlink should be mounted on an overhang.
- Page 5 5. Set the two sealing tape strips over the six holes where the volcano mount will sit. 6. Line the six holes on the mount over the six pre-drilled holes. Starting with the center holes, drive lag bolts ~90% in.
- Page 6 Route the loose end into your Avoid puncturing cable and sharp home and connect to the power bends, and follow horizontal/ supply. vertical lines. Never set the Starlink directly onto roof. Directly place the Starlink into mount and remove carrying bag.
- Page 7 Connected to the Internet Ensure your hands and other objects are out of the way of the Starlink. If the Starlink does not connect to the internet within 30 minutes, power cycle by unplugging and reconnecting the black cable to the power supply.
- Page 8 • Are you installing your Starlink at the address you used when placing your order? 3. If none of these work, contact Starlink Customer Support by logging into your account on starlink.com. Change Network ID/Password 1. If you already have a network ID/password set up, press the reset button at the bottom of your router.