Publicité
Les langues disponibles
Les langues disponibles
WARNING: SHOCK HAZARD. DO NOT allow any liquid to get inside the charger. Electric shock may result.
WARNING: BURN HAZARD. DO NOT submerge the battery pack in any liquid or allow any liquid to enter the
battery pack. Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack
breaks or cracks, return to a service center for recycling.
TRIGGER LOCK BUTTON
from activating. To advance crimping piston, move the trigger lock button into
the unlocked position. To lock trigger and restrict piston from advancing, depress
the trigger lock button.
ADVANCE TRIGGER
: Press the trigger to advance the crimping piston. Press
1
the trigger until the dies have fully compressed the connector. You will hear
an audible click and see the GREEN crimp LED
has reached 700 bar (12 ton) pressure, and the operation is complete. If you
continue to hold the trigger after crimp cycle is complete, the motor will stop.
RETRACT TRIGGER
: Press the retract trigger to release hydraulic pressure
2
and retract the crimp piston. The tool is designed to retract the crimp piston only
after complete 12 ton crimp is achieved. If crimp force has started, the retract
button will not function until the crimp cycle is completed.
QUICK-RELEASE DIES
5
1. To insert or remove the lower die, press the button on the end of the piston
and slide the die into the opening of the C-head, along its groove. NOTE: For
easier access, slightly advance the crimp piston.
2. To insert or remove the upper die, push the button on the end of the head
and slide the die into the head, along its groove.
WARNING: DO NOT complete full crimp cycle without dies properly inserted.
WARNING: Remove the battery cartridge before placing the dies.
CRIMP INDICATOR LED
10
indicates the status of the crimp.
1. The LED light will illuminate GREEN when the tool has reached full 12-ton
force and a crimp has been successfully completed. NOTE: Once a crimp has
begun, it is possible (but not recommended) to retract the piston before the
crimp is completed.
2. When this tool is operated correctly, it takes approximately seven (7) seconds
to complete one full cycle and complete a compression. If the tool is used for
10 seconds and does not reach full 12 Ton pressure, the tool motor will stop.
If the green LED is not lit, this indicates there is a problem with the tool.
DO NOT attempt to repair; please contact an authorized Klein Tools service
center to repair the tool.
LIFT RINGS
: Two lift rings are intended for moving the tool into hard-to-reach
9
areas. Securely fasten lifting device to the ring before moving the tool. Follow all
worksite rules.
WARNING: To reduce the risk of serious personal injury, DO NOT use the
lift ring for tethering or securing the tool to a person or object during use
when elevated.
BATTERY CHARGING INSTRUCTIONS
FUNCTIONALITY
: The Trigger Lock will restrict Advance Trigger
3
, indicating that the output
10
:
: The LED is located on the top of this tool and
1
3
1
4a
5b
4b
4b
10
2
5a
4a
9
9
Publicité
