Publicité
Les langues disponibles
Les langues disponibles
Requirements for Use
Requirements for
use
Transportation
requirements
This appliance must be connected to a 220/240
V 50 Hz mains electricity supply using an
earthed plug.
It must be protected with a 10 A slow-action
fuse.
Should an extension lead be needed, this lead
must be at least 1,5 mm
more than 25 m. long and earthed.
There is a cavity at the back of the appliance for
the mains electricity supply connection wire.
Do not allow water to enter the appliance.
Do not block the air inlets or outlets on your
appliance, especially when used for heating,
especially when using the heating function.
Should the mains electricity supply wire be
damaged in any way, it must only be replaced with
a wire of similar characteristics. Get in touch with
the manufacturer, after-sales service or similarly
qualified person.
Warning!
If the appliance is turned off and then turned
back on again, there is a 3-minute interval
before the compressor starts up again. This
interval is necessary in order for the appliance
to work properly.
There are castors fitted on your appliance to make
moving it easier. If it is necessary to tilt your
appliance in order to move it, then the internal
water tank must be drained first. To do this, connect
drainage pipe to stopcock at the bottom of the
appliance.
Warning!
Be particularly careful when transporting this
unit. There is a water drainage pipe on the
bottom of the appliance which may break if
knocked.
2
per terminal thick, no
21
Publicité
