Nikro PS1000 Mode D'emploi page 4

Purificateur d'air droit

Les langues disponibles

Your #PS1000 Air Scrubbing System has been thoroughly tested and inspected at the factory and is fully assembled and

ready for use. However, prior to plugging the unit in, inspect it for any damage that may have occurred during shipping.

Inspect and tighten the HEPA filter hold down nuts, which may have loosened during transportation.

ELECTRICAL RATING:

115V

3.5 Amps

60 HZ

FILTER SET-UP PROCEDURES

The Model #PS1000 Air Cleaning unit is equipped with three stages of filtration as follows:

#860958 1" Polyester Filter Pad (1

#860959 2" Pleated Filter (2

#862176 H.E.P.A. Filter (99.97% efficient @ 0.3 microns) (Final Stage)

Hold the dolly handle and tilt the unit back until it is laying horizontal on the floor and

resting on the dolly handle and rear wheels. (See Photo 1 & 2)

Slide the #862176 HEPA filter into the cabinet housing and allow the threaded HEPA hold

down rod (located inside the cabinet housing mounted on the back wall) to pass through

the hole located on the HEPA filter end cap. Make sure that the HEPA filter drops into the

back socket of the housing and that the gasket flange is resting on the outside of the

cabinet housing. (See Photo 3 & 4)

Slide #862282 Rubber backed washer over the threaded HEPA filter hold down rod push it

down thread making sure the rubber gasket on the washer rests against the HEPA filter

end cap. (See Photo 4)

Take the #862281 HEPA filter tightening knob and thread it onto the threaded HEPA filter

rod. (See Photo 6) WARNING: DO NOT USE TOOLS TO TIGHTEN THIS KNOB! Hand

tighten as tight as possible, making sure that the gasket on the #862282 rubber backed

washer is compressed. (See Photo 5)

Lift the machine up into the upright position. Unclamp the 4 latches and remove the intake

door with the flange, which is located on the top of the machine. (See Photo 6)

Place #860959 2" Pleated Filter inside the housing cabinet this filter should be placed on

the rubber sealing gasket with the air flow directional arrows on the filter pointing down

towards the motor and blower assembly. (See Photo 7)

Take the #860958 1" Filter Pad and place it on top of the pleated filter. (See Photo 8)

Set the intake door with flange on top of the unit and snap the four latches into the locked

position. (See Photo 9)

Unit is ready for use.

Stage)