Publicité
Les langues disponibles
Les langues disponibles
D.
4
2
Snap temperature control cover over temperature
control knob by first aligning smaller tab (1) on
cover with receiving slot (2) on temperature knob.
Swing larger tab (3) to engage with snap feature
(4). Note: If dis-assembly is required, reverse
this motion, disengaging larger tab (3) from snap
feature (4) first.
5
Potential scald or thermal shock injury could result due to cross flow if outlet at the shower
is blocked or restricted (e.g., pause control on hand shower). Be sure to point hand shower
away from you when re-starting flow or install inlet check valves on both supply lines to
prevent possible injury.
6
Diverter handle Installation
1
3
4
Diverter Handle Installation
Slide diverter handle (1) onto trim sleeve (2).
Using a allen wrench, insert set screw (3) into
handle (1). Applying pressure, insert set screw
cover (4), if included, until properly seated.
1
2
3
7
107532 Rev. F
Publicité
