Audizio RP114 Serie Manuel D'instructions page 5

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed
to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your device. Leave the device switched off until it has reached room temperature.
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the
mains voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit
must also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
1. Platter
Place your record here.
2. 45 RPM adapter
This adapter allows you to play 45 RPM records.
3. Tone arm
The fixed tonearm can be raised and lowered by hand, or by
using the raise /lower lever.
4. Arm clip
This arm clip secures the tonearm while at rest or when not
in use. The arm clip has been designed to remain in the up
position whilst unlocked.
5. Cartridge with needle
When the turntable is not in use, it is recommendable to
place the removable protection cover on the stylus.
6. Tone arm lever
Use to raise/lower the tone arm.
7. Autostop switch ON/OFF
This switch turns the auto stop-function on/off. When the
automatic stop is enabled, the platform will start rotating as
soon as the tone arm is placed over the record and will stop rotating when it has reached the end of the record. Some vinyl
records stop before the end or do not stop when the end is reached. In this case set Auto-stop to OFF.
8. 33 / 45 / 78 RPM switch
Use to adjust the RPM setting of the turntable platter.
9. Led power indicator
10. Power & volume control knob
To power on the record player, rotate this knob clockwise until it clicks. When powered on, use this knob to adjust the
volume for the internal speakers and headphones. To turn off the record player, rotate this knob counter clockwise until it
clicks.
11. Headphone input
Connect your headphone with this 3.5mm (1/8) jack connector.
12. USB type B / power input
Use the included USB cable to connect your turntable to your computer. The USB connection will send audio from the
turntable to your computer.
This USB connection is also for the power supply.
13. AUX input
3.5mm auxiliary input jack.
14. Line output
RCA line output to connect external speakers (not included).
• Remove the record player from the package box.
• Plug in the power supply and turn on the device.
• Caution: Use only the cable supplied with the unit. Connecting a power supply with a different rating can cause permanent
damage to the unit and may be hazardous.
• Place the record on the turntable. If required, place the 45rpm adapter on the record spindle.
• Choose the desired playing speed using the speed selection switch (33-, 45- or 78rpm).
• Rotate the power & volume control knob clockwise to turn the device on, note that this is also the control of the volume.
• Make sure that any protective cover is removed from the stylus.
• Unlock the tone arm by releasing the tone arm clip.
• Raise the arm by using the tone arm lever.
5