Hart HPSD85 Manuel D'utilisation page 7

OPERATION
Extended periods of sanding may tend to overheat the
motor. If this occurs, turn the sander off and wait until the
sanding sheet comes to a complete stop, then remove it
from workpiece. Remove your hand from the vent area,
remove the sanding sheet, then with your hand removed
from vent area, turn the sander on and run it free without a
load to cool the motor.
For detail sanding such as corners and crevices, use the
tip of the sanding pad with small back and forth motions.
CHANGING SANDING SHEETS AND PADS
See Figure 8, page 9.
To change sheets and pads, simply pull the used sheet off
the base and attach the desired sheet by pressing the sheet
or pad onto the base of the sander.
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.
ACCESSORIES
Accessories for this product may be ordered online at www.HARTtools.com or where you purchased this product.
n Vacuum adaptor ................................................................................................................................................... HASD85
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or
accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recom-
mended can result in serious personal injury.
NOTE: ILLUSTRATIONS START ON PAGE 8
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
ROTATING THE SANDING SHEETS
See Figure 9, page 9.
The majority of wear in a precision sanding application occurs
at the tip of the sanding sheet. The unique Tri-Flex design of
the sanding sheets allows you to detach and rotate the top
two thirds of each and extend the life of the sheet.
To rotate the top of the sheet, simply remove the top two
thirds along the perforation. Rotate the sheet so that a clean
corner is located at the tip of the base. Press the sheet firmly
onto the pad.
NOTE: Scrubbing and polishing pads are not perforated and
cannot be rotated.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
7 – English