Blaupunkt 5WK820FF0R Notice D'utilisation page 40

Temperature display in Fahrenheit. F
F
Display shows lower zone temperature at its setting.
G
G
Compartment selecting switch (lower or upper one). Once the compartment has been
H
selected, it will show setting temperature as flash, 5 seconds later flash will stop and setting
H
temperature will be showing
H
Alarm cancel switch, press once to cancel the alarm. Press and hold 5 seconds to change
I
Celsius or Fahrenheit.
I
Light ON/OFF switch, turn on and turn off the light. J
J
Temperature selection
The wine cooler has two temperature zones. The temperature setting of upper zone is
adjustable with the range 5-12°C, which is ideal for storing sparkling and white wines. The temperature
setting of lower zone is adjustable with the range 12-20°C, which is ideal for storing white and red
wines.
NOTE: both zones temperature could be set at 12ºC, and it is workable at the same
time. But for optimal performance, once one zone is set at 12ºC, we suggest another setting
for the other zone with 3°C difference at minimum (example: 5°C upper and 8°C lower).
Maximum temperature difference between both compartments is 10°C. Always set cooler
temperature in the upper compartment and warmer temperature in the lower compartment
(example: 5°C upper and 15°C lower).
• To select the temperature zone, press (H) once, upper zone will flash, (H) key
pressing again to switch it to lower zone. Setting temperature could only be set under display flash
status.
• You can touch key "+" (C) and key "-" (B) to set the internal temperature for the
selected zone. The degrees indicators will appear in the display window marked
and for lower zone.
• When the unit is plugged in for the first time, the LED readouts will show the original
temperature set previously. Touch the "+" (C) and "-" (B) mark once of each compartment to set
the desired temperature.
• The temperature will increase by 1°C or 1ºF if you touch the "+" (C) mark once, or
the temperature will decrease by 1°C or 1ºF if you touch the "-" (B) mark once.
When the surrounding temperature is 25℃ and the wine cooler has no bottle
loaded, it will take around 12 minutes to increase the wine cooler's temperature from
5℃ to 12℃. Under the same circumstance, it will take around 25 minutes to decrease the
wine cooler's temperature from 12℃ to 5℃. The less the temperature span is, the less
time it will take. The setting temperature of upper zone should be lower than the setting
temperature of lower zone
Temperature display
Display show at its setting.
To view the actual temperature in either zone at any time, touch key (B) and key (C) for 3
second, the display will display two zone's actual temperature with flashing, and it will quit by holding
stop.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the
inner temperature will not immediately be the temperature setting on the display. Indeed, it is
necessary to wait a few hours for a temperature adjustment of the wine cellar in order to have a
homogeneous temperature. To avoid excessive condensation when the ambient temperature is above
EN
for upper zone