tomado Superior TWD7525B Mode D'emploi page 15

hold down the ON/OFF button for 5 seconds to stop the green indicator led from flashing.
STORAGE
Empty the water reservoir in the sink and clean the hot water dispenser before storing it. Preferably store it in the original box
to prevent corrosion and damage as a result of moisture.
PROBLEMS & SOLUTIONS
If there is a problem, please first check the following solutions before contacting customer service.
Problem
The flow-through speed has
reduced.
The green indicator led flashes.
Water is leaking from under
the appliance.
The appliance no longer works.
This symbol means that this product should not be disposed of with regular household waste (2012/19/EU). Observe
the rules that apply in your country for the separated collection of electric and electronic products. Correct disposal
of the product prevents negative consequences for the environment and for public health. The packaging material
of this product can be recycled 100%, return packaging material separately.
Possible cause
Scaling reduces the heating speed.
After 10 hours of use, it is time
to de-scale the appliance.
The rubber cap on the bottom has
not been properly tightened.
It is possible that the overheating
safety device has been activated.
RECYCLING
EN - 15
Solution
The appliance must be de-scaled.
De-scale the appliance as described
above. After de-scaling, hold down
the ON/OFF button for 5 seconds
to stop the green indicator led
from flashing
Properly tighten the rubber cap
at the bottom.
Use a small pin to press down
the reset button in the top right side
of the recess at the front, in order
to reset the appliance.
11