Home Accents Holiday TG76P3739X02 Instructions D'assemblage

TM
TREE ASSEMBLY INSTRUCTIONS
Pre-Assembly
Package Contents
Part Description
A Tree top
B Tree center,
C Tree bottom,
D Tree stand
Assembly
Assembling the tree stand
Step 1.Choose a location near a wall outlet.
Step 2.Unfold the legs of the tree stand (D) and lay the stand
on the floor.
Step 3.Slide the locking disk of the tree stand (D) down until
it snaps into place.
Assembling the tree
Each tree section is numbered with a sticker. Please identify
all sections before assembling.
Step 1. Assemble the tree from the bottom (C) to the top (A).
Start with the bottom section (C) and remove
protective cap before inserting into the assembled
stand(D). Make sure the pole is firmly inserted and
secured into the stand(D).
Step 2. Please remove protective cap from middle section(B)
and continue inserting into the bottom section (C).
Step 3. Insert the tree top (A) into the tree center (B).
Step 4. Allow branches to fall into place or gently pull up and
out.
Step 5. Begin to shape the branches and tips working from
the bottom to the top. Start with tips farthest from
the pole and fan out one to the right, one to the left
and one at the center of the main stem.
Step 6
. Shape the tree from the bottom to the top. Start with the
branches farthest from the pole – fan out in a star shape,
and continue until the entire tree is shaped.
Top view
Step7. After shaping the entire tree following the previous
step, slightly upsweep all branch tips for a uniform
look. Shift branches to fill any gaps. Your Christmas
tree is now complete and ready to be decorated.
Quantity
1
2 1
sticker
1 1
sticker
1
Side view
Section 2
Section 1
Maintenance
Spare parts
This tree package includes hinge pins and washers for any
replacement or repair that you need to perform on your tree.
If extra parts are needed, contact the Customer Service Team
at 1-877-527-0313 between the hours of 8 am and 5 pm EST,
Monday through Friday.
Repairing Loose Hinges
Step 1. Extra hinge pins are included for repairing the hinges.
Place the branch into the slot of the bracket
Step 2. Insert a new hinge pin through the holes of the bracket
and secure with a washer.
Care and Cleaning
Step 1. Remove all ornaments and decorations.
Step 2. Disassemble the tree from the top to the bottom.
Start with the tree top and gently lift straight up to
remove from section below and fold all branches
toward the pole.
Step 3. In case of difficulty separating the tree pole (trunk),
apply a small amount of lubricant at the joint and
rotate the upper pole in both directions. Lift up the
upper pole again.
Step 4. Continue by gently lifting straight up each section(s)
from the section below and fold all branches toward
the pole until the bottom section is removed from
the tree stand.
Step 5. Carefully place all tree sections into shipping box
and tape it shut.
Step 6. When not in use, please store your tree in a cool, dry
place away from sunlight. Exposing your tree to
excessive heat or humidity may damage your tree.
Christmas Tree
Model# TG76P3739X02
Sku # 1000 834 595
Tree top