Glacier bay 15606 Instructions D'assemblage page 3

Pre-Installation
PLANNING INSTALLATION
To ensure your installation goes smoothly, please read these instructions carefully and review the recommended tools and hardware before
you begin.
To remove the old vanity (if applicable): 1) Turn off the water supply and drain out. 2) Disconnect the supply lines from the faucet.
3) Remove the old vanity top and vanity. If the new vanity is not installed immediately, temporarily stuff a rag into the drain pipes.
Using a level, locate any uneven floor and/or wall areas where your vanity will be installed. Unevenness can cause your vanity to become
misaligned resulting in twisting of the cabinet. Repair any uneven areas by reducing high spots or shimming low spots.
TOOLS REQUIRED
Electric drill
with #2 drill bit
Pliers
HARDWARE INCLUDED
NOTE: Hardware shown to actual size.
Part Description
AA Handle
BB 1 in. screw
Two #8 x 2 in.
screws
Safety
goggles
BB
Quantity
Two wall
anchors: if the
vanity will not
be screwed to
wall studs
Phillips
screwdriver
1
2
3
Please contact 1-855-HD-GLACIER for further assistance.
Level
Silicone
(optional)
AA
HOMEDEPOT.COM/GLACIERBAY