Ryobi STM405 Installation

DOOR MAGNET INSTALLATION
Use the following instructions to install the door magnets
included in your STM405 LINK cabinet packaging.
WARNING:
KEEP AWAY FROM ALL CHILDREN! Do not put in nose
or mouth. Swallowed magnets can stick to intestines
causing serious injury or death. Seek immediate medical
attention if magnets are swallowed or inhaled.
INSTALLING MAGNETS
See Figures 1 - 2.
NOTE: For ease of installation, install the magnets onto the
cabinet doors before installing doors onto the cabinet.
„ Locate (2) magnets included with Door Magnet Installation
guide.
„ Lay cabinet doors flat with interior of door facing up.
„ Remove magnets from bag and separate.
„ Locate the lower corner of the cabinet door on the
opposite side of the hinge rods and measure 1/8 in. from
the bottom of the door and 1/8 in. from the side of the
door. This will be the magnet installation point.
„ Remove paper backing from the magnet to expose
adhesive.
„ Press the magnet adhesive side down onto the magnet
installation point as shown.
RYOBI is a trademark of Ryobi Limited and is used pursuant to a license granted by Ryobi Limited.
STM405
TTI CONSUMER POWER TOOLS, INC.
P.O. Box 1288, Anderson, SC 29622
Phone 1-800-525-2579
États-Unis, Téléphone 1-800-525-2579
USA, Teléfono 1-800-525-2579
www.ryobitools.com
Fig. 1
C
A - Magnet (aimant, imán)
B - Inside of left door (intérieur de la porte gauche, interior de la puerta
izquierda)
C - Inside of right door (intérieur de la porte droit, interior de la puerta derecha)
D - Hinge rod (tige de la charnière, varilla de la bisagra)
Fig. 2
A
B
A - Paper backing (papier de l'aimant, parte trasera de papel del imán)
B - Magnet (aimant, imán)
D
B
1/8"
A
1/8"
999000263
4-27-23 (REV:01)