Koenic KCI21 Serie Notice D'utilisation page 24

en
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Fig. $
Lift the glass shelves, pull forwards,
lower and swivel out to the side.
Condensation channel
Fig. %
Regularly clean the condensation
channel and drainage hole with a cotton
bud or similar implement to ensure that
the condensation can drain.
Take out shelves in the door
Fig. &
Lift shelves upwards and take out.
Tips for saving energy
Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Select 560 mm cavity depth.
■
A smaller cavity depth will result in
a higher energy consumption.
Allow warm food and drinks to cool
■
down before placing in the appliance.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
■
possible.
24
To avoid increased power
■
consumption, occasionally clean the
back of the appliance.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.
Operating noises
Quite normal noises
Droning
Motors are running (e.g. refrigerating
units, fan).
Bubbling, humming or gurgling noises
Refrigerant is flowing through the tubing.
Clicking
Motor, switches or solenoid valves are
switching on/off.
Preventing noises
The appliance is not level
Please align the installation cavity with
a spirit level. To do this, use the height-
adjustable feet of the cavity or place
something underneath.
Containers or storage areas wobble
or stick
Please check the removable parts
and re-insert them correctly if required.
Receptacles are touching each other
Move the receptacles slightly away from
each other.